© 2019, CyberData Corporation, ALL RIGHTS RESERVED.
931695B
Quick Reference
Installation Procedure
To install the Syn-Apps Ceiling Tile Drop-In Speaker, complete the following steps while referencing the figure
below:
1. Remove the Ceiling Tile (Showing a 2 x 2 Grid) from the Ceiling Grid then Cut it in Half.
2. Place the Cross T in the Middle to Support the Weak Side of the Ceiling Tile.
3. Replace the Ceiling Tile on to the Ceiling Grid.
4. Use a Flat Blade Screwdriver to Pry Up the Seismic Tether Bracket(s) on the 1 x 2 Ceiling Tile Speaker
Assembly.
5. Install Eyebolt(s) or Nail(s) to the Joist.
6. Connect the Network Cable to the Network Port and Wire(s) to the Terminal Block, etc. to the 1 x 2 Ceiling Tile
Speaker Assembly.
7. Use Steel Wire(s) to Connect Seismic Tether Bracket(s) to the Eyebolt(s) or Nail(s).Place the 1 x 2 Ceiling Tile
Speaker Assembly on to the Ceiling Grid and the Cross T.
Installing the Syn-Apps Ceiling Tile Drop-In Speaker
Use a Flat Blade Screwdriver
to Pry Up the Seismic Tether Bracket
Joist
Eyebolt / Nail
Cross T
*
*
*
*
*
Speaker Assembly
2 x 2 Ceiling Tile
Steel Wire
1 x 2 Ceiling Tile
2
8
4
5
1, 3
6
7
