Installing the VoIP Intercom
Intercom Setup
Operations Guide
930242M
CyberData Corporation
30
3. After changing the parameters, click the
Save
button.
Enable Push to Talk
This option is for noisy environments. When enabled, the
microphone will be muted normally. When the button is
pressed and held, it will unmute the microphone and allow
the operator to send audio back.
NOTE
: When
Enable Push to Talk
is enabled, you cannot
stop an active call with the call button. The device on the
other end will need to end the call.
NOTE
:
Enable Push to Talk
will not work on some older
hardware.
Click the
Save
button to save your configuration settings.
Note
: You need to reboot for changes to take effect.
Click on the
Test Audio
button to do an audio test. When
the
Test Audio
button is pressed, you will hear a voice
message for testing the device audio quality and volume.
Click on the
Test Relay
button to do a relay test.
Click on the
Test Microphone
button to do a microphone
test. When the
Test Microphone
button is pressed, the
following occurs:
1. The device will immediately start recording 3 seconds of
audio.
2. The device will beep (indicating the end of recording).
3. The device will play back the recorded audio.
Click on the
Reboot
button to reboot the system.
Table 4-7. Device Configuration Parameters (continued)
Web Page Item
Description
