Installing the VoIP Intercom
Intercom Setup
Operations Guide
930242M
CyberData Corporation
17
4.1.7 Announcing the IP Address
To announce a speaker’s current IP address, first determine if you have an Intercom with an RTFM
switch (see
SW1
), and then do one of the following:
• If you have an Intercom that has an RTFM switch, then see
Section 4.1.7.1, "Intercom with an
• If you have an Intercom that has a jumper and does not have an RTFM switch, then see
4.1.7.2, "Intercom with a Jumper and No RTFM Switch"
4.1.7.1 Intercom with an RTFM Switch
1. If you have an Intercom with an RTFM switch, then press and hold the RTFM switch (see
SW1
in
) until the IP address is announced.
2. Release the Call Button after the IP address is announced.
Figure 4-9. RTFM Switch (SW1 Button)
