ii
Safety Instructions
1.
Always read the safety instructions
carefully.
2.
Keep this equipment away from humidity.
3.
Lay this equipment on a reliable flat surface before setting it up.
4.
The openings on the enclosure are for air convection hence protect the
equipment from overheating. DO NOT COVER THE OPENINGS.
5.
Confirm the voltage of the power source and adjust accordingly to 110/220V
before connecting the equipment to the power inlet.
6.
Place the power cord in such a way that it cannot be stepped on. Do not
place anything over the power cord.
7.
Always unplug the Power Cord before inserting any add-on card or module.
8.
All cautions and warnings on the equipment should be noted.
9.
Never pour any liquid into the opening. This will cause damage and/or electrical
shock.
10.
Do not disable the protective grounding pin from the plug. The equipment must be
connected to a grounded main socket/outlet.
11.
The Optical Storage devices are classified as Class 1 Laser products. Use of
controls or adjustments or performance of procedures other than those specified is
prohibited.
12.
Do not touch the Laser lens inside the optical storage drive.
13.
If any of the following situations arise, have the equipment checked by authorized
service personnel:
•
The power cord or plug is damaged.
•
Liquid has penetrated into the equipment.
•
The equipment has been exposed to moisture.
•
The equipment has not worked well or you cannot get it working according to
the User's Guide.
•
The equipment has been dropped and damaged.
•
The equipment has obvious signs of breakage.
DO NOT LEAVE THIS EQUIPMENT IN AN UNCONDITIONED ENVIRONMENT WITH A
STORAGE TEMPERATURE ABOVE 50° C (122°F). IT MAY DAMAGE THE
EQUIPMENT.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer.
