36
A. CT-10G-MC series HyperTerminal Command – system
Command Descriptions – system
show
The
system show
allows you to view CT-10G-MC series’ PCB/firmware/FPGA
versions, as well as hardware temperature.
show
The
system user show
command allows you to view the current
users and their passwords.
admin
The
system user admin [name | password]
<name | password>
command allows you to change the user name and its password of the
user with administrator privilege. For example, if you type in
system
user admin name test123
and press enter, a user named
test123
with
administrator privilege
will be created.
user
guest
The
system user guest [name | password]
<name | password>
command allows you to change the user name and its password of the
user with guest privilege. For example, if you type in
system user
guest name test123
and press enter, a user named
test123
with
guest privilege
will be created.
show
The
system devname show
command allows you to view the device
name assigned to CT-10G-MC series.
devname
set
The
system devname set [device name]
command allows you to
view the device name assigned to CT-10G-MC series.
show
The
system snmp show
command will show the current SNMP
(Simple Network Management Protocol) settings.
writecommunity
The
system snmp writecommunity <parameter>
allows you to set
the community with write privilege. The
<parameter>
can be
public
,
private
,
or
user names
.
snmp
readcommunity
The
system snmp readcommunity <parameter>
allows you to set
the community with read privilege. The
<parameter>
can be
public
,
private
,
or
user names
.
save
The
system save
command allows you to save the current settings to CT-10G-MC
series
NV-RAM. Please note that all unsaved settings will be lost after system reboot.
system
update firmware/FPGA
The
system update [firmware/FPGA]
commands allow you to
upgrade CT-10G-MC series’ firmware/FPGA. The following
descriptions are for upgrading CT-10G-MC series’ firmware. However,
proced ures for upgrading CT-10G-MC series’ FPGA are quite the
same and can be related.
1. Type in “
system update firmware
” and click
enter
. Press
Y
to
proceed and start upgrading firmware, or press
N
to cancel.
2. Press
Transfer
on HyperTerminal’s menu bar and choose “
Send
File
”.
