CyberPower CP1000AVRLCDa, User Manual

REPLACING THE BATTERY 

- continued

Yellow Wire to (+)Red Connector 
Black Wire to (-)Black Connector 

Red Wire to (+)Red Connector 
Yellow Wire to (-)Black Connector 

6.   Disconnect the battery wires from the batteries.
7.   Remove the batteries from the compartment.
8.   CP850/1000AVRLCD: Install the replacement batteries by connecting the red wire (+) and 

black wire (-) to the same color connectors.

9.   CP1500AVRLCD: Install the replacement batteries by connecting the red wire (+) and black 

wire (-) to the same color connectors from both the upper and lower battery pack. Note: 

Only use new batteries for replacement and both batteries should be replaced at the same 

time to ensure maximum life span.

10.  Put the batteries back into the compartment.
11.  Slide back the battery compartment cover and tighten the retaining screws.
12.  Recharge the UPS for 8-16 hours to fully charge the battery. 

CP1350AVRLCD

1.   Turn off and unplug all connected equipment.
2.   Turn the UPS off and unplug it from the AC power source.
3.   Turn the UPS on its side.
4.  Remove two retaining screws located on the bottom of the UPS.
5.   Slide the battery compartment cover completely off of the unit.
6.   Remove the battery which is located on the right side from the compartment.
7.   Disconnect the battery wires from the right side of the battery.
8.   Slide the remaining battery from left to right and remove it from the compartment.
9.   Disconnect the battery wires from the remaining battery.
10. Install the “left side” replacement battery by connecting the yellow wire (+) to the red  

connector from the battery and the black wire (-) to the black connector from the battery. 

Place the battery into the left side of the compartment.

11.  Install the “right side” replacement battery by connecting the red wire (+) to the red  

connector from the battery and yellow wire (-) to the black connector from the battery.  

Place the battery into the right side of the compartment. Note: Only new batteries should  

be used for replacement and both batteries should be replaced at the same time to insure 

maximum life span.

12.  Slide back the battery compartment cover and tighten the retaining screws.
13.  Recharge the UPS for 8-16 hours to fully charge the battery.

REMINDER:

 Batteries are considered 

HAZARDOUS WASTE

 and must be disposed of properly. Most retailers that sell lead-acid 

batteries collect used batteries for recycling, as required by local regulations.