background image

COMMUNICATION SIGNALS

                                               

LIMITED WARRANTY

CyberPower warrants to you, the Initial Purchaser, that the Product will be free from defects in material and workmanship for three years from the date of original purchase, subject to the terms of this Limited 
Warranty. This Limited Warranty gives you specific rights, and you may have other rights, which vary from State to State or Province to Province.

Any Implied Warranty of Merchantability or for Fitness for a Particular Purpose, if applicable to the Product, is limited in duration to three years. This provision shall NOT create any Implied Warranty or 
Merchantability or of Fitness for a Particular Purpose that would not otherwise apply to the Product. NOTE: 

Some States and Provinces do not allow limitations on how long an implied warranty lasts, 

so the above limitation may not apply to you.

To be covered you must still be the owner of the Product at the time of the failure that results in the claim made under this Limited Warranty. Your sole and exclusive remedies are those provided by this 
Limited Warranty. This exclusion of other express warranties applies to written and oral express warranties. CyberPower excludes any liability for personal injury. CyberPower excludes any liability for direct, 
indirect, special, incidental, or consequential damages, whether for damage to or loss of property, loss of profits, business interruption, information or data. This exclusion applies even though damage or loss 
is caused by negligence or other fault.  NOTE: Some States or Provinces do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you.

DO NOT USE FOR MEDICAL OR LIFE SUPPORT EQUIPMENT OR OTHER HIGH RISK ACTIVITIES.
CyberPower does not sell the PRODUCT for use in high-risk activities. The PRODUCT is not designed or intended for use in hazardous environments requiring fail-safe performance, including the operation 
of nuclear facilities, aircraft navigation or communication systems, air traffic control, weapons systems, life support or medical applications or for use in any circumstance in which the failure of the PRODUCT 
could lead directly to death, personal injury, or severe physical or property damage, or that would affect operation or safety of any medical or life support device (collectively, "High Risk Activities"). 
CyberPower expressly disclaims any express or implied warranty of fitness for High Risk Activities. CyberPower does not authorize use of any PRODUCT in any High Risk activities. 
ANY SUCH USE IS IMPROPER AND IS A MISUSE OF A CHARTER PRODUCT.

The Limited Warranty is governed by the laws of the United States, without reference to conflict of law principles. The application of the United Nations Convention of Contracts for the International  
Sale of Goods is expressly excluded.

FCC NOTICE :

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. 

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with these instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1)Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an
experienced radio/TV technician for help.

CAUTION:

 Shielded signal cables must be used with this device to ensure compliance with Class A FCC limits.

CAUTION:

 Any changes or modifications not expressly approved by CyberPower could void the authority granted by the FCC to operate this equipment.

K01-3424000-00 

SPECIFICATION

       

     

   

Voltage Range

100Vac - 240Vac

 

 

Frequency Range

50-60Hz

Output

Output Voltage

24Vdc

Continuous Power Capability

Total 34W

Efficiency (Max Load)

≥80%

 

Battery

Battery Type
Numbers of Battery

4S2P

 

 

Typical Recharge Time

 

24 Hours

  

 

Replaceable

Surge Protection and Filtering

 

 

Lightning / Surge Protection

 

Management

Battery Auto-Charge

 

Yes

Physical

Dimensions (LxWxD)

20.1cm x 12cm x 9.45cm 

Weight (Net)

 

1.3 kg (with 14.8V/6500mAh battery)

 

Environment

Operating Temperature

   

32ºF - 104ºF (0ºC - 40ºC) 

Operating Humidity
Max Operating Elevation

 

10,000ft (3,048m)

50,000ft (15,240m)

 

CyberPower Systems ( USA ), Inc. 4241 12th Avenue East, Suite 400, Shakopee, MN55379 Phone: (952)403-9500 Fax: (952)403-0009 www.cyberpowersystems.com

CyberPower Systems ( EUROPE ), Inc. www.cyberpowersystems.com

Model

BAS34U24V

Deliver spent batteries to a recycling facility or ship to the manufacturer in the 
replacement battery packing material.

Input

0-95% noncondensing within enclosure

Yes

Yes

14.8V/6500mAh

18650 Lithium-ion Rechargeable Battery

Max Storage Elevation
Storage Temperature

32ºF - 104ºF (0ºC - 40ºC) 

8 PIN DC output connector

1

1

8

2 PIN DC output connector

2 1 2

Communicate port (SNMP RMCARD205)

The communication signals of this unit are isolated from the internal circuitry via open  
collector opto-coupled transistors. The connection “SIG RTN” (Signal Return) is a common 
return point for all communication signals. In the typical application, the attached equipment 
digital ground connects to Signal Return, and pull-up resistors turn the open collector 
signals into logic levels.

Signal

Pin

Pin Function

External _

 

 

External _charger -

 

AUX_TXD 

 

AUX_RXD 

 

O

 

Output1 -

 

External _BAT IN +
External _BAT IN -

Pin Number

1
2
3
4
5
6
7

8

VOUT +

Pin Number

Pin Function

VOUT -

1
2

This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment may cause radio interference.

Operation of this equipment in a residential environment could cause radio interference.

This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

WAMING:

WAMING:

WAMING:

Reviews: