CZGL AT-16
CyberResearch
®
CPU Cards
82
©Copyright 2009
CyberResearch, Inc.
Step 3:
Insert the cable connectors
.
Once the cable connector is properly aligned with
the 26-pin box-header connector on the CZGL AT-16, connect the cable
connector to the on-board connector. See
Figure 5-9.
Figure 5-9: LPT Cable Connection
Step 4:
Attach the LPT connector to the chassis
. To secure the LPT interface
connector to the chassis please refer to the installation instructions that came
with the chassis.
Step 5:
Connect LPT device
. Once the LPT interface connector is connected to the
chassis, the LPT device can be connected to the LPT interface connector. See
Figure 5-13
Step 0:
\
5.8.7 SATA Drive Connection
The CZGL AT-16 is shipped with two SATA drive cables and one SATA drive power cable.
To connect the SATA drives to the connectors, please follow the steps below.
Step 1:
Locate the connectors
. The locations of the SATA drive connectors are shown
in
Chapter 3
.
Summary of Contents for CZGL AT-16
