CZGL AT-16
CyberResearch
®
CPU Cards
84
©Copyright 2009
CyberResearch, Inc.
Figure 5-11: SATA Power Drive Connection
5.8.8 USB Cable (Dual Port) with Slot Bracket
The CZGL AT-16 is shipped with a dual port USB 2.0 cable. To connect the USB cable
connector, please follow the steps below.
Step 1:
Locate the connectors
. The locations of the USB connectors are shown in
Chapter 3
.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2:
Align the connectors
. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the CZGL AT-16 USB connector.
Step 3:
Insert the cable connectors.
Once the cable connectors are properly aligned
with the USB connectors on the CZGL AT-16, connect the cable connectors to
the on-board connectors. See
Figure 5-12
.
Summary of Contents for CZGL AT-16
