CZGL AT-16
CyberResearch
®
CPU Cards
68
©Copyright 2009
CyberResearch, Inc.
5.6 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three
metal pins and a small metal clip (often
protected by a plastic cover) that slides over
the pins to connect them. To CLOSE/SHORT
a jumper means connecting the pins of the
jumper with the plastic clip and to OPEN a
jumper means removing the plastic clip from a
jumper.
Jumper Locations
Before the CZGL AT-16 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the CZGL AT-16 are listed in
Table 5-1
.
Description
Label
Type
AT/ATX power selection
ATXCTL1
J_AUTOPWR1
3-pin wafer
2-pin header
CF card setup
JCF1
2-pin header
Clear CMOS
J_CMOS
3-pin header
COM 2 function select
JP1
8-pin header
LCD panel resolution selection
J_LCD_TYPE1
8-pin header
LVDS voltage selection
J_VLVDS
3-pin header
Table 5-1: Jumpers
Summary of Contents for CZGL AT-16
