CZGL AT-16
CyberResearch
®
CPU Cards
70
©Copyright 2009
CyberResearch, Inc.
Jumper
ATXCTL1
J_AUTOPWR1
ATX
Connect to PS_ON#
and 5 VSB
Open
Table 5-2: AT/ATX Power Selection Jumper Settings
5.6.2 Clear CMOS Jumper
Jumper Label:
J_CMOS1
Jumper Type:
3-pin header
Jumper Settings:
See
830H
Table 5-3
Jumper Location:
See
Figure 5-3
If the CZGL AT-16 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
832H
Table 5-3
.
AT Power Select
Description
1-2
Keep CMOS Setup
2-3
Clear CMOS Setup
Table 5-3: Clear CMOS Jumper Settings
Summary of Contents for CZGL AT-16
