Shenzhen Zhiyong Electronics Co., Ltd.
6
6 (RF output port):
Standard BNC RF output port used for connecting receiver or spectrum
analyzer. Because EM5040A has a 10dB transient limiter inside, so the receiver need to set
corresponding correction factor
7 (Artificial Hand function):
This function will simulate the actual influence when human
hand touched the metal part of the handle tool. It is composed with 510Ω resister and 200pF
network. 4mm port is used for connecting the metal part for human contact handle
equipment
4.2
EM5040B Front panel introduction
1 (L1 indicator):
When powered up, the indicator will be lighted up blue.
2 (EUT power port):
The product’s power port is Germany Standard. At the same time the
accessories in the product provide national standard adapter head.
3 (Reference Ground Port):
4mm port is used for connecting the ground port of DUT.
4 (N/L1):
The switch selecting the phase line under test.
5 (9 kHz/150kHz Switch):
The filter switch.
6 (Channel Selection):
Switch the output signal to the corresponding ports including RF
Output
，
CM Output
，
DM Output
7 (Artificial Hand function):
this function will simulate the actual influence when human
hand touched the metal part of the handle tool. It is composed with 510Ω resister and 200pF
network. 4mm port is used for connecting the metal part for human contact handle
equipment
8 (CM OUTPUT Port):
Standard BNC RF Female port is used for connecting receiver.
Output voltage is Vout=[VN+VL ]/2
－
10dB. With fixed 10dB transient limiter inside, the
receiver needs to set corresponding corrected attenuation factor.
9 (RF output port):
Standard BNC RF Female port is used for connecting 10dB transient
limiter inside, so the receiver need to set corresponding corrected attenuation factor
10 (DM Output Port):
Standard BNC RF Female port is used for connecting receiver.
Output voltage is Vout=[VN-VL) ]/2
－
10dB. With fixed 10dB transient limiter inside, the
receiver needs to set corresponding corrected attenuation factor.
CYBERTEK
