CyberView RKP117 Series, User Manual

UM-CV-751-RKP117-Q413V5 www.austin-hughes.com

■

   It is very important to mount the equipment in a suitable cabinet or on a stable surface.

■

   Make sure the place has a good ventilation, is out of direct sunlight, away from sources of excessive    

      dust, dirt, heat, water, moisture and vibration.

The equipment comes with the standard parts shown in package content. Check and make sure they are 
included and in good condition. If anything is missing, or damaged, contact the supplier immediately. 

Unpacking

Before Installation 

How To Clean Your LCD Monitor  

Caution : 

■

   To avoid the risk of electric shock, make sure your hands are dry before unplugging your monitor from or

       plugging your monitor into an electrical outlet.

■

   When you clean your monitor, do not press down on the LCD screen. Pressing down on the screen can 

      scratch or damage your display. Pressure damage is not covered under warranty. 

■

   Use only cleansers made speci

fi

 cally for cleaning monitors and monitor screens. Cleansers not made to 

      clean monitors and monitor screens can scratch the LCD display or strip off the 

fi

 nish.

■

   Do not spray any kind of liquid directly onto the screen or case of your monitor. Spraying liquids directly 

      onto the screen or case can cause damage which is not covered under warranty.    

■

   Do not use paper towels or abrasive pads to clean your monitor. Using an abrasive pad or any wood based

      paper product such as paper towels can scratch your LCD screen.

Cleaning Your Monitor 

To clean your LCD safely, please follow these steps :

  Disconnect the power cord.

       Gently wipe the surface using a clean, dry micro

fi

 ber cloth. Use as little pressure as possible.

1

2

Cleaning Tough Marks and Smudges                     

To remove tough marks and smudges, please follow these steps :

     Disconnect the power cord.

        Spray a small amount of non-abrasive cleanser on a micro

fi

 ber cloth.

        Gently wipe the surface. Use as little pressure as possible.

        Wait until your monitor is completely dry before plugging it in and powering it up.

1

2

Caution : Do not spray or apply any liquids directly onto the monitor. Always apply the solution to your 
microfi ber cloth fi rst, not directly on the parts you are cleaning.

3

4