14
Setup Mode
The 400T’s Setup mode allows you to configure the four following
features:
1. Memory Retention Mode
2. Metric/English Measurement Units
3. Programs On/Off Mode
4. Time Limits (in Manual mode, only)
5. Pause On/Off Mode
The description of each feature, as well as the procedure to access
the Setup mode, is listed below:
Note: The Setup mode can be accessed only while the treadmill is in
the dormant mode, i.e., the On/Off switch must be turned On (I) and
the treadmill belt must not be moving.
To enter the Setup mode, press and hold the SHIFT key for three
seconds. The left and right display windows will illuminate. The left
display window will show the status of the memory retention mode
as either “on” or “oFF.” The right display window will show the
status of the measurement units, “E” for English or “nn” for metric.
To advance to the Program On/Off mode, press the SHIFT key once
after entering the Setup mode. The left display window will indicate
the status of the Program On/Off mode as either “P on” or “Poff.” If
“Poff” is selected, the right display window will indicate the time
limit setting in minutes.
To advance to the Pause On/Off mode, press the SHIFT key once again.
The left display window will indicate the status of the Pause On/Off
mode as either “on” or “oFF.” The right window will display, “PAUS.”
1. Memory Retention Mode
The memory retention mode feature remembers the last program
number, program level and weight setting used.
Memory Retention On: When this feature is enabled (“on”), the 400T
uses your last program values as the new default program, level, and
weight, replacing P1 and 160 lb. (73 kg) as the standard defaults. The
memory retention feature is convenient, if you consistently use the
same program routine, because it allows you to quickly start the
treadmill by simply pressing START twice. The stored default values
are automatically entered from the last workout.
Additionally, the memory retention mode allows you to review your
last program, program level, maximum grade, maximum speed,
calories burned (CAL) and DISTANCE run, by pressing the SHIFT
key when in the dormant mode.
Memory Retention Off: Setting the memory retention mode feature
to “oFF” resets the 400T defaults to the standard values. The
standard program default is P1 (Manual Mode) and the standard
default weight setting is 160 lb. (73 kg). You can toggle the Memory
Retention mode “on” and “oFF” by using the
▲
and
▼
keys.
3 / G
ETTING
S
TARTED
Summary of Contents for 400T
