Page 5-6
Cybex 600T Treadmill Service Manual
Drive Belt
11. Re-tension the drive belt.
A.
Place the drive belt tensioning roller in position under the front bracket on the drive
belt tensioning assembly. See Figure 5.
B.
Place the two steel bar springs over the drive belt tensioning roller plate and under
the front bracket on the drive belt tensioning assembly. Be sure springs are firmly
seated against the stop under the drive belt retainer. See Figure 5.
C.
Be sure that the pulley is aligned with the drive belt.
D.
Place the washers and mounting bolt on top of the drive belt tensioning assembly.
See Figure 5. Tighten the mounting bolt while keeping the pulley aligned with the
drive belt.
NOTE:
The deck top is waxed and should not be flipped top to bottom. However, the
deck can be rotated 180 degrees. The holes used are symmetrical.
12. Attach the running deck.
A.
Attach the ten bolts, eighteen washers and two belt retaining washers which hold
the deck to the treadmill frame. See Figure 4.
Rear Roller
13. Replace the rear roller.
A.
Slide the rear roller into the running belt.
B.
Loosely attach the bolts, springs, and washers, in position
'
on the rear roller. See
Figure 3.
C.
Tighten each of the bolts evenly. Make sure not to tighten one bolt too many turns
before moving to the other bolt.
14. Adjust the running belt tension and center the belt. See Running Belt
Adjustments in the Preventative Maintenance chapter. Then continue with step
15.
!
WARNING: When installing the side rails be sure
to
wear work gloves
to
protect
against any sharp edges.
15. Reinstall the side rails and end caps.
A.
With works gloves on, slide the side rails onto the base and guide them onto the
four mounting studs on each side of the base.
Summary of Contents for 600T
