Page 5-18
Cybex 600T Treadmill Service Manual
6. Replace the main power switch
if
needed.
A.
Unplug the old power switch and replace it by plugging in the new power switch.
Power Cord Inlet
NOTE:
If
you are replacing the power cord inlet with
a
new one follow step
7.
If
not, skip
to step 8.
7. Replace the main power cord inlet if needed.
A.
Remove the two Phillips head screws which hold the power cord inlet in place.
B.
Plug the main power lines (black and white wires) and the ground wires (green and
yellow) into the lower control board. See Figure 11 and 14.
NOTE:
Refer to the Diagrams section to see
a
wiring diagram.
8. Replace the lower control board shield.
A.
Check to see that all of the cables are connected firmly in their proper place. Be
sure to route the wires through the retaining clips as shown in Figure 11.
B. Attach the shield over the lower board bracket using the two clips. The red and
black motor cables will go under the corner of the shield.
9. Replace the front end cap.
A.
Replace the front end cap using the three Phillips head screws.
10. Attach the motor cover.
A.
Place the rear of the motor cover in the rear guide holes.
B.
Lower the front end of the motor cover and install the two Phillips head screws
that hold it
in
place.
Display Board
Tools Required
• Phillips head screwdriver
1. Turn the power off.
A.
Turn the main power switch in the front panel to the off (0) position.
B.
Unplug the treadmill from the power outlet.
Summary of Contents for 600T
