Cybex Owner’s Manual
31
Setup
Use the following instructions to setup the units settings.
1.
Plug the optional power cord and E3 View Monitor power cord (E3 View Monitor units only)
into a power outlet from a grounded circuit, See
Electrical Requirements
. Coil up the
remainder of the power cord and place it out of the way. The control panel will light up and be
in the Dormant Mode.
2.
Hold the handrails to steady self while stepping into the pedals.
3.
Begin pedaling.
Initial setup
Perform this procedure during the installation of the unit. Once complete, refer to Setup Options
below.
1.
Press the
Cybex
logo icon
to display the
Access Toolbox
and
Lock Screen
options.
2.
Press the Access Toolbox icon to display the
Access to Toolbox
login screen.
3.
Enter the sequence:
.
4.
Press the Setup icon to display the
setup
menu
.
5.
Tap the
Time
icon to advance to the
Set the Time
screen.
6.
Adjust the time if needed, then tap the
ENTER
icon
.
7.
Tap the
Date
icon to advance to the
Set the Date
screen.
8.
Adjust the date if needed, then tap the
ENTER
icon
.
9.
Tap the
Units
icon to select the Set units preference screen.
10.
Select the unit preferences from the following options:
Distance Units
Weight Units
Miles
Lbs.
Km
Kg.
Stone
Exit Set Up Mode by tapping the
Toolbox
icon
, then tap the
Home
icon
. The screen will
refresh.
