Cybex Owner’s Manual
35
If no TV numbers appear, no UHF transmitters were discovered. Verify the UHF transmitters are
powered on and set to their respective TV numbers (1,2,3, etc.) or toggle the Near/Far setting and re-
scan.
Review channels
1.
Tap
Up
or
Down
to listen to available channels with the headphones.
2.
Delete unwanted channels by pressing
Delete
to delete channel. Repeat process for additional
unwanted channels.
3.
Tap
Up
or
Down
to scroll through and verify all TV channels. If all TV transmitters
are stored, and they all correlate the TV number to the correct TV heard, setup is complete. If
all channels did not show up in the scan as expected, toggle the Near/Far setting and re-scan
the transmitter codes (see documentation for your transmitters to perform a code change.)
4.
Tap
Toolbox
then
Home
to exit setup. Transmitter setup complete.
5.
Press
Show All
to confirm the TV numbers correspond to the frequencies entered.
6.
Proceed to
Add FM Radio Stations (optional)
.
Setup TV FM Transmitters
If your TV’s use FM transmitters, follow these instructions to assign a TV channel to each frequency.
1.
Tap
Setup
at the main
Toolbox
screen.
2.
Tap
Scroll Right
to navigate to the
A/V Config
icon.
3.
Tap
A/V Config
to enter
TV Configuration
.
4.
Tap
Select Xmtr
to select your transmitter type as “TV FM”.
Enter TV channels using one of the following procedures
•
Tap
Seek
to seek the next TV FM frequency or
Up
or
Down
to tune manually. Press
Add
to store channel.
•
Tap the keypad numbers to enter known channel, Press
Enter
and
Add
to store channel.
5.
Repeat procedure to add all TV FM channels.
