Cybex Owner’s Manual
47
OSD Language
1.
Tap ▲ or ▼ to select
OSD Language
.
2.
Tap ◄ or ► to select language.
ATSC choices
English, Français or Español.
DVB-T choices
English, Français, Español, Dutch, Danish, Russian, German, and Swedish.
3.
Tap the
Setup
icon to return to SETUP MODE menu.
Exit Set Up Mode by tapping the
Toolbox
icon
, then tap the
Home
icon
. The screen will
refresh.
Setup Complete
Testing the Operation
Use the following instructions to test the full resistance range of the unit:
1.
Plug the optional power cord into a power outlet from a grounded circuit, See
Electrical
Requirements
. Coil up the remainder of the power cord and place it out of the way. If you do
not have the optional power supply, skip to step 3.
2.
Verify the control panel will illuminate and is in
Dormant Mode
.
3.
Hold the handrails to steady self while stepping into the pedals.
4.
Begin pedaling.
5.
Tap
QUICK START
icon on the CardioTouch screen.
6.
Run unit through full resistance range. First press the
RESI
key until unit reaches
its highest load (the display will show “21”). Then press the
RESISTANCE -
key until unit
reaches its lowest load (the display will show “1”). The resistance should increase and
decrease while pedaling.
When unit reaches the set resistance, the displays will stop flashing and remain steadily illuminated to
indicate the desired setting has been reached.
CAUTION: Serious injury or damage to machine can occur. To avoid injury or damage
the following procedure must be followed. Wait until all moving parts come to
a complete stop before dismounting.
7.
Wait until pedals come to a complete stop before dismounting the unit. Hold the handrails to
steady self while stepping off the unit.
