3. Place Child Restraint rear-facing on selected vehicle seat. Make sure it is not
blocking the vehicle belt buckle.
4.
Installation on Level Ground:
Locate the Level Indicator label and readjust the
seat recline to any position that the ball falls within the blue zone for
REAR-FACING
installation.
5.
Installation on a Slope:
Locate the Level Line on the blue label near the
Rear-Facing Belt Path. Adjust the seat recline so that the Level Line is level
with the ground.
Installation Options:
*LATCH installation
continued on page 33.
*Lap/Shoulder Belt installation
continued on page 37.
*Lap Belt Only installation
continued on page 39.
1. Make sure the vehicle is on level ground, if possible.
2. Squeeze the Recline Adjustment Handle
a
on front of Child Restraint and pull
forward to adjust to a reclined position as shown
b
. Only use recline positions
1 through 6 for rear-facing use.
Do not use Tether in
REAR-FACING
mode.
Tether must be properly stored - See "Tether Storage" page 16.
Infants may have difficulty breathing when in an upright seated
position. Make sure they recline enough for their head to lie back
comfortably and safely. Failure to properly recline the Child Restraint
could increase the child’s risk of serious injury or death.
32
31
1 2 3 4
5 6
7 8 9
10
1 2 3 4
5 6
1 2 3 4 5 6 7 8
9 10
RE
AR
-FA
CIN
G
Storage
BEL
T P
A
TH
5 - 40 lbs (2.3 - 18 kg)
and top of head at least
1 in.
(2.5 cm) below top of headrest
Shoulder Straps
for Rear-Facing
should be at or
just below child’
s
shoulders.
LA
TCH
LAP
BEL
T
LAP/
SHOULDER
BEL
T
Rear-Facing Level Line
CY_171_2203
R
EA
R
-FA
CIN
G
Sto
rag
e
BEL
T P
A
TH
5 - 40 lbs (2.3 - 18 kg)
and top of head at least
1 in. (2.5 cm
) below top of headr
est
Shoulder
St
raps
for
Rear-Facing
should
be
at
or
just
be
low child’
s
shoulders.
LA
TCH
LAP
BEL
T
LAP
/
SHOULDER
BEL
T
Rear-Facing Level Line
C
Y
_1
71
_2
20
3
3
2
5
4
a
b
REAR-FACING SETUP
REAR-FACING SETUP
EN
REAR-F
ACING
