CHECK YOUR WORK
• HOLD Child Restraint at each side near Rear-Facing Belt Paths. Pull side to
side and forward. Child Restraint should not move more than 1 in. (2.5 cm) from
vehicle seat back or side-to-side.
• Make sure Child Restraint is level for rear-facing use (p. 31-32). Make
sure child's head does not fall forward. If necessary, loosen the LATCH Strap,
readjust recline and repeat installation steps to make sure Child Restraint is
installed properly.
• Check installation before every use.
5. Locate the LATCH anchor bars in your vehicle. Attach both LATCH Connectors
to the vehicle LATCH anchor bars.
6. While pushing down on the Child Restraint, pull up on the end of the LATCH
Adjuster Strap until strap is tight using adjuster on either side of the Child
Restraint.
Note:
Pull the end of each LATCH Adjuster Strap by reaching through the
Rear-Facing Belt Path
a
on the inside of the Child Restraint.
36
35
10
9
1
2
3
4
5
6
7
8
ARMP
IT LE
VEL
10
9
1
2
3
4
5
6
7
8
ARMP
IT LE
VEL
5
6
a
CLICK!
CLICK!
INSTALL REAR-FACING USING LATCH
INSTALL REAR-FACING USING LATCH
EN
REAR-F
ACING