cycli
Commands
286
AlterPath OnBoard Administrator’s Guide
The
add
command is used instead of
set
when multiple parameters of the
same type can exist. For example,
add network hosts
IP address
makes an entry for a host with the specified IP address in the
hosts
list. In
that case,
add
is used because multiple hosts can exist.
In contrast, the
set
command (
set network interface eth0
IP
address)
is used to specify the IP address for one of the Ethernet interfaces. In
that case, the set command is used because each interface has only one IP
address
.
Adding certain parameters causes one or more related parameters to be added.
For example, in the case where an IP address is added to the
hosts
list,
empty
hostname
and
alias
parameters are also added. Until values are
set
for empty parameters, the
get
or
show
commands list the parameter
names without any values.
Also as shown in the screen example, you must add parameters in a prescribed
order. Because the empty
hostname
and
alias
parameters are created
when you add a host’s IP address, you cannot add a host by name before
specifying the host’s IP address, and you cannot specify the host name at the
same time as its IP address. To specify a
name
or
alias
for a host you need
to add the host first by adding its IP address, then you need to use the
set
command to specify its name and alias.
Summary of Contents for AlterPath OnBoard
