Web Manager "Settings" Menu Options
131
Configuring the AUX Port for Modem or Power Management
Figure 5-7:
Settings
→
AUX Port
→
Modem
T
To Configure an AUX Port for Modem Access
This procedure assumes that an external modem is connected to the AUX port
of the OnBoard. The values to select or to enter for modem configuration are
described in Table 1-20 on page 44.
1.
Log into the Web Manager as an administrative user.
2.
Go to Settings
→
AUX Port.
3.
Make sure the “Modem” option is selected from the “Profile” menu.
4.
Choose Autodetect, Login, or PPP from the “Modem access” menu.
5.
Select a baud rate from the “Baud Rate” pull-down menu.
6.
If you chose Autodetect or Login, select an option from the “Flow
Control” menu.
7.
Enter a modem chat string in the “Modem Initialization” field.
8.
If you chose PPP or Autodetect, do the following:
a.
Enter a IP address or accept the default provided in the “Local IP
address” field.
b.
Enter a IP address or accept the default provided in the “Remote IP
address” field.
c.
Enable or disable authentication by checking or leaving unchecked
the “Authenticating Required” checkbox.
d.
Accept or change the value in the MTU field.
e.
Accept or change the value in the MRU field.
Summary of Contents for AlterPath OnBoard
