Introduction
61
Understanding Private Subnets on the OnBoard
Understanding Private Subnets on the OnBoard
Connected devices should be isolated (as recommended under
“Understanding Device Configuration” on page 53) on a management
network that is separate from the production network and from the public
network. With the recommended configuration, the OnBoard administrator
must create at least one private subnet for communicating with connected
devices. The administrator must then assign to each connected device the
following two address-related parameters:
•
The name of the private subnet
•
An address within the private subnet’s address range to be used by devices
when communicating with the OnBoard
If a device is not assigned a private subnet, the OnBoard attempts to contact
the device using the default route, which cannot work unless the device is
connected to a network on the public side of the OnBoard.
For more details about setting up subnets, see the following related topics.
•
“Understanding Address Configuration for Connected Devices” on page
336
•
“Configuring Private Subnets and Virtual Networks” on page 251
Private subnets can be configured in the Web Manager on the Wizard Subnets
screen or on the Network Private Subnets screen as described in:
•
“Configuring Private Subnets and Virtual Addresses—Wizard” on page
98
•
“Configuring Private Subnets and Virtual Networks” on page 251.
Summary of Contents for AlterPath OnBoard
