7
126221.PDF
KF096/
2.5 mm
Loctite® 242 (blue)
1.1 Nm, 9.7 InLbs
LIGHT GREASE
M4(.8)X14
5 Nm, 44 InLbs
Loctite® 242 (blue)
CHAINSTAY
DROPOUT
OUTER BOLT
REAR DERAILLEUR
HANGER
INNER BOLT
R
E
AR
DE
RA
ILLEU
R
H
ANG
E
R
Clean and carefully inspect the dropout for any cracks or
damage before replacement. Apply a light film of bike grease
to the dropout to minimize any noise or “creaking” that might
result from very slight movement between the dropout and
hanger during movement of the derailleur. Apply grease and
Loctite carefully.
Check derailleur adjustment after replacement. Readjust
wheel quick release so it is very tight. See PART I Section 4. A
in your Cannondale Bicycle Owner’s Manual.
The smaller M4 size outer bolt threaded into the inner may be
used as connecting point for compatible fenders /racks. Be
sure to use the specified Loctite and a torque wrench when
tighening this fastener.
N
OTICE
■
Do not use a derailleur hanger alignment
tool to straighten. If bending adjustment is
necessary, remove the hanger from the frame
first.
■
The larger inner connecting bolt inner
is permanently bonded in place. Do not
attempt to removed it.
Make sure the outer bolt is installed and
tightened even if a fender/rack is not used.
R
E
AR
D
R
OPOUT
Summary of Contents for cannondale QUICK FULL CARBON 2012
Page 19: ......
