14
V1.0
DMX Protocol
1 Channel Mode
Function
Function Control
CH1
Dimmer
000-255: 0-100% dimmer
2 Channels Mode
Function
Function Control
CH1
Dimmer
000-255: 0-100% dimmer
CH2
Strobe
000-255: Strobe with speed increasing
3 Channels Mode
Function
Function Control
CH1
Dimmer
000-255: 0-100% dimmer
CH2
Dimmer fine
000-255: 16 bit dimmer
CH3
Strobe
000-255: Strobe with speed increasing
Fixture Cleaning
Due to fog residue, smoke, and dust cleaning the internal and external optical lenses and mirror should
be carried out periodically to optimize light output. Cleaning frequency depends on the environment
in which the fixture operates (I.e. smoke, fog residue, dust, dew). In heavy club use we recommend
cleaning on a monthly basis. Periodic cleaning will ensure longevity, and crisp output.
To clean the fixture:
1.
Disconnect the fixture from power and allow it to cool for at least 10 minutes.
2.
Vacuum or gently blow away dust and loose particles from the outside of the fixture with low-pressure
compressed air.
3. Clean the surfaces by wiping gently with a soft, clean lint-free cloth moistened with a weak detergent
solution. Do not rub glass surfaces hard: lift particles off with a soft repeated press. Dry with a soft,
clean, lint-free cloth or low-pressure compressed air. Remove stuck particles with an unscented
tissue or cotton swab moistened with glass cleaner or distilled water.
4.
Check that the fixture is dry before reapplying power.
Fuse Replacement
This fuse is located in a fuseholder next to the MAINS OUT socket on the connections panel.
To replace a fuse:
1.
Disconnect the fixture from power and allow it to cool for at least 10 minutes.
2.
Unscrew the cap of the fuseholder and remove the fuse. Replace with a fuse of the same size and
rating only.
3. Reinstall the fuseholder cap before reapplying power.
Troubleshooting
Listed below are a few common problems that you may encounter, with solutions.
The fixture does not work, no light
•
Check the connection of power and main fuse. Be sure the external fuse has not blown.
•
Measure the mains voltage on the main connector.
