The information contained in this document is derived from the TFT LCD Display Guide provided by Tianjin APT Science and
Technology Co., Ltd. (otherwise known as APT). All the information contained in this user manual is published in good faith
and for general information purpose only. Contact
technical_support@cycmotor.com
APT 750C DISPLAY
Assembly Information
Note the torque requirements described above as excessive torque can cause damage.
Compatibility
The clamps are suitable for 3x different handlebar sizes: 31.8mm, 25.4mm, and 22.2mm.
There are transfer rings included for 25.4mm and 22.2mm (marked with L or R) as shown
below. Be sure to pay attention to the directions below to insert the transfer rings correctly.
M4*10
Torque requirements:
STD = 0.1 N.m.
MAX = 0.2 N.m
M3*8
Torque requirements:
STD = 0.25 N.m.
MAX = 0.4 N.m
