1
．
Use the supplied template to determine the correct location and size of mounting holes for both the door and frame header. Ensure that
the door opens away from the Maglock. In the case of a single door, the Maglock is positioned as close as possible to the vertical section
of the door jamb.Drill door and frame as indicated.
2
．
Loosely install the mounting plate using two of the supplied Philips head mounting screws in the elongated slots. Attach the Maglock to
the mounting plate.
3
．
Using a hammer, lightly tap both roll pins into the armature plate until they are secure.
4
．
Before installing the Hexnut, the hole in the door may need to be drilled or tapped. Refer to page 2 for this information. Using the componets
shown in the image to the right, mount the armature to the door. Make sure that the armature plate is not over tightened and that it is installed
as shown in the following diagram. The armature plate must be free to self align with the door.
5
．
Ensure the armature and magnet are aligned. Adjust the mounting plate to suit and then drill the appropriate sized holes in the door
header for the remaining attachment screws.
6. Close the door to test holding force. The angle between armature plate and magnetic lock can be adjusted by adding or reducing washers.
5. Disassemble Procedure
6. Standard Mounting Method
6
1
2
3
4
5
7. Bracket Mounting Method
For in-swing door, install the lock body inside
and then need to install the ZL bracket at the
same time.
Magnetic locks installed in glass doors
require extra U bracket (for 10-15mm
glass door thick).
W h e n t h e d o o r w i d t h i s l e s s t h a n 4 2 m m
the width is not enough for Armature Plate
of the magnetic lock installed, it need to
add the additional L type bracket.
