20
Notes:
The OSD only provides controls for the collaboration Receiver’s functions.
To control the functions of both the collaboration Transmitter and
Receiver, please use the WebGUI or Telnet.
Items in
Bold
are factory default settings. The individual functions will be
introduced in the following paragraphs.
►
Output Resolution
Due to the possibility of selecting an output resolution or format
that is not supported by the connected display, after selecting a new
resolution the OSD will display a confirmation screen. If “YES” is not
selected on the confirmation screen within 12 seconds, the output
resolution will change back to the previous setting.
When the output resolution is set to “Bypass”, the scaler in the Receiver
will be disabled and the “Output Image Adjust” menu will be disabled
and greyed out. However, the “Output Colour Format” menu’s options
can still be adjusted.
►
Output Colour Format
Format:
If “Auto” is selected, and the sink’s EDID does not correspond
to the CEA-861 specifications, this will be set to HDMI.
Colour Space:
The “YUV 4:2:0” colour space can only be selected when
the output resolution is 4K@50Hz or 4K@60Hz. When the Format is
“DVI”, the colour space selection will be grayed out and automatically
set to “RGB”.
Colour Depth:
When the Format is “DVI” or the colour space is “YUV
4:2:2”, the Colour Depth section will be grayed out and automatically
set to “8-bit”.
►
HDMI Information
Notify:
When the input state changes, the OSD will automatically
display the currently detected input resolution for the selected period
of time.
When connected to a collaboration Transmitter the OSD Info function
will be replaced by the Transmitter’s OSD Banner and controlled via
the WebGUI's settings.
