2
5. FEATURES
• HDMI with 4K2K supported, HDCP and DVI compliant
• Output source signal to 4 displays as a full image with adjustable
Bezel Correction
• Input PC resolutions support from VGA~WUXGA and HDTV from
480i~1080p and 4K2K@24/25/30Hz
• Supports different input resolutions and output resolutions selectable
from TV wall application
• Supports AC3/DTS/Dolby Digital Plus/Dolby TrueHD/Dolby Atmos
and DTS-HD Master Audio
• Supports RS-232 and Telnet controls
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
4K UHD
POWER
POWER
1X4 UHD TV WALL
CDPS-4KQ
1
1
POWER:
Press POWER button to power on the unit or set to standby
mode.
When power is disconnected, presses this button and connected
the power to reset the system back to default factory setting.
When power is on, long press this button for 3 seconds, output
monitor will show “USB Host Update MCU Firmware Start…”, then
plug USB (with Firmware upgrade bin file contained) to upgrade
automatically. If monitor shows “Mass Storage Host Upgrade
Running” it means that the upgrade is proceeding, after upgrade
finished, the unit will reboot.
Note: If monitor didn’t show “Mass Storage Host Upgrade Running”,
means firmware upgrade didn’t success, please power off the unit
and try again.