4
6.2 Rear Panel
IR IN
HDMI 1
HDMI 2
SERVICE 2
COAX
AUDIO
AUDIO
AUDIO 7
AUDIO 1
AUDIO 2
AUDIO 3
AUDIO 4
HDMI
BYPASS
CAT5e/6/7
CAT5e/6/7
CAT5e/6/7
PC
HDMI 1
HDMI 2
HDMI 3
HDMI 4
5
6
7
INPUT
R
L
CV
8
LAN
RS-232
DC 24 V
OUTPUT
IR OUT
SERVICE 1
ON
OFF
DSP PROG.
1
2
6
8
13
14
16
5
7
3
4
7
9
10
12
15 17
11
1
IR OUT:
Connect to the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
2
IR IN:
Connect to the supplied IR Extender cable for IR signal
reception. Ensure that remote being used is within the direct line-
of-sight of the IR Extender.
3
OUTPUT CAT5e/6/7:
Connect to the Receiver unit with a Single
CAT5e/6/7 cable for transmission of all data signals.
4
OUTPUT HDMI:
Connect to a HDMI equipped TV/monitor for display
of the HDMI input source signal.
5
OUTPUT COAX:
Connect to audio sound equipment such as
speaker or amplifier for audio sound output.
6
OUTPUT AUDIO:
Connect to audio sound equipment such as
speaker or amplifier for audio sound output.
7
SERVICE 1& 2:
These slots are reserved for firmware update use
only.
8
DSP PROG Switch:
This switch is reserved for firmware update use
only. Default setting is on OFF.
9
BYPASS:
Connect to a HDMI equipped TV/monitor or DVI equipped
monitor with audio sound equipment such as speaker for both
video and audio output display.
10
INPUT HDMI 1~4 & AUDIO 1~4:
Connect to HDMI source equipment
such as DVD or Blu-ray player along or to DVI source equipment
along with audio source signal.
11
INPUT CAT5e/6/7:
Connect this port to HDMI to CAT5e/6/7
Transmitter with CAT5e/6/7 cable to extend the signal up to 100m.
12
INPUT PC & AUDIO:
Connect this port to PC/Laptop with audio
signal for input signal selecting.
