18
COMMAND
Description and Parameters
get automation event N1 uart A
Show the current state of the specified Automation Event’s RS-232
response.
N1
= 1~3
[Automation Event number]
set automation event N1 uart A delay N2 sce
Set the delay time that the specified Automation Event must continue to
be true before sending the defined RS-232 command.
N1
= 1~3
[Automation Event number]
N2
= 0~240
[Delay in seconds]
get automation event N1 uart A delay
Show the delay time for the specified Automation Event’s RS-232
response.
N1
= 1~3
[Automation Event number]
set automation event N1 uart A wait N2 sce
Set the length of time to wait after an Automation Event’s RS-232
response has been activated before ANY other Automation Event can
be detected.
N1
= 1~3
[Automation Event number]
N2
= 0~240
[Delay in seconds]
get automation event N1 uart A wait
Show the wait time for the specified Automation Event’s RS-232 re
-
sponse.
N1
= 1~3
[Automation Event number]
Note: Commands will not be executed unless followed by a carriage return.
Commands are not case-sensitive.
Summary of Contents for CH-2538TXM-TB
