DRAFT
4
6.3 Receiver Front Panel
POWER
RS-232
IR OUT
IR
USB
1
2
3
4
LINK PAIR SEL
LINK
1
ON
2 3 4
2
3
4
5
6
7
1
1
POWER LED:
The LED will illuminate when the device is connected
with power.
2
LINK LED: The LED will illuminate when the Receiver is linked with
Transmitter.
3
RS-232: This slot is to connect with D-Sub 9-pin female null modern
cable from PC’s system for controlling both the input source and
output display over RS-232.
4
IR OUT: Connect with IR Blaster included in the package for IR
signal received from Transmitter side to blast out and to control the
desire device.
5
IR window: To receive the remote control signal and send to
Transmitter side for IR signal blast out.
6
LINK PAIR SEL: This dip switch allows user with matrix setting for link
up to 16 pairs of the devices with single IP router. Each pair must
have the same dip switch setting in order to pair to the right device
setting. The factory default setting is at 0000.
7
USB 1~4: Connect USB devices such as keyboard, mouse, thumb
drive, hard disk and …etc. for data sending or control over USB
connected devices.
