28
6.6.3 Network Tab
The Network tab provides controls over the Transmitter’s broadcast
channel, IP configuration, and network broadcast mode. Changes
made to the network settings will require a reboot of the unit. After
clicking on “Apply” please follow the reboot instructions in the
WebGUI.
Note: If the IP address is changed then the IP address required for
WebGUI access will also change accordingly. If the new address is
assigned via “Auto IP” or “DHCP” it might be necessary to temporarily
disable the Video Link between the Receiver and Transmitter in order
to display the units’ new IP addresses on the Receiver’s HDMI output.
Press and hold the LINK button for 3 seconds to enable or disable the
Video Link.
• Channel Setup
Use the dropdown to select the broadcast channel for the Transmitter.
All Receivers on the local network that are set to the same channel
will receive video from this Transmitter. The available channel range is
from 0 to 255.
Note: Every Transmitter within the same local network must be
assigned a different broadcast channel in order to avoid conflicts.
• IP Setup
This section allows for configuration of the IP acquisition mode and