CYP CHDBT-1H3CE, Operation Manual

4

6.2 Rear Panel

MODE

LINK

MODE

LINK

MODE

LINK

IR IN

IR OUT

LAN

2

3

1

CAT5e / 6 / 7   OUT

1

2

3

4

1

IR IN: 

Connect the supplied IR Receiver cable for IR signal 

reception. Ensure that remote being used is within the direct line-

of-sight of the IR Extender

.

2

IR OUT:

 Connect the supplied IR Blaster cable for IR signal 

transmission. Place the IR Blaster in direct line-of-sight of the 

equipment to be controlled.

3

LAN:

 Connect to an active network for LAN serving. When any 

compatible LAN equipped receivers are connected, this allows 

the network access (including internet access if available) to be 

shared. Connect any Ethernet equipped device e.g. a Smart TV 

or games console to the LAN port of a receiver for that device to 

share the network/internet access.

Warning: DO NOT connect the LAN connection with any of the 

CAT5e/6/7 outputs, doing so may trigger a power shut down and 

may damage the device.

4

CAT5e/6/7 OUT 1~3:

 Connect to CAT5e/6/7 to HDMI Receivers (with 

or without PoE) with a single CAT5e/6/7 cable each to extend the 

HDMI signal up to 100 m.

MODE LED: 

This LED will illuminate when the power is connected.

LINK LED: 

This LED will illuminate when connected to a Receiver unit 

that is connected to a TV/monitor that is displaying the signal.