3
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
SYNC
LINK
EDID
SERVICE
HDMI IN
POWER
HDMI OUT
DC 24V
STD
TV
1
2
3
4 5
6 7
8
1
HDMI IN:
Connect to HDMI equipped source equipment such as a
DVD/Blu-ray player or games console.
2
SYNC LED:
This LED will illuminate when the HDMI input is connected
to a HDMI source and receiving a signal.
3
HDMI OUT:
Connect to a HDMI display for local monitoring of the
HDMI signal or cascade to another Splitter.
4
HDMI LINK LED:
This LED will illuminate when HDMI output is
connected to TV or display monitor and receiving a signal.
5
EDID STD/TV:
The default setting is TV, when in this mode, the unit
will detect the EDID settings of the display device connected to
the CAT 5e/6/7 Output 1. If it detects a 4K×2K capable EDID setting
it will transmit the signal in that format to the output port. If no 4K×2K
capable EDID is detected then the unit will detect the EDID settings
and send out the signal that all outputs can accept.
This device has a last memory function and will retain the EDID
settings of the last device connected via the CAT5e/6/7 output
port when it is not connected to a display after power cycling.
Switch to the STD setting to use the unit's built-in EDID if there are
display problems. In this mode, the video output will be set to
1080p@60Hz and the audio at LPCM 2CH Stereo.
6
SERVICE:
Reserved for manufacture use only.
7
POWER LED
: The LED will illuminate when connected to an active
power supply.
8
DC 24V:
Connect the 24V DC power supply to the unit and plug
the adaptor into an AC outlet.
