13
RS232 CONTROL
2ND LEVEL
3RD LEVEL
Baud 115200
Local
Baud 2400
Baud 4800
Baud 7200
Baud 9600
Baud 14400
BAUD 19200
Baud 38400
Baud 57600
Baud 115200
1) Mode:
Set the operational mode of the RS-232 port on the unit.
Selecting “Command” allows direct control of the unit via RS-232.
Selecting “Pass Through” allows extension of RS-232 signals to all
connected HDBaseT receivers.
2) Port A~D:
Set the supported baud rate for RS-232 extension over
each HDBaseT port. Selecting “Disabled” will block RS-232 from
being extended over that port.
Note: Baud rate conversion will be performed automatically if the
local baud rate and destination port baud rate are different.
3) Local:
Set the baud rate to use on the local RS-232 port.
IR CONTROL
2ND LEVEL
3RD LEVEL
Ch A~D
ENABLE BIDIRECT
Disabled
Enable Emitter
Enable Receiver
Local
ENABLE BIDIRECT
Disabled
Enable Emitter