CYP CLUX-18EU, Operation Manual

4

6.2 Rear Panel

SERVICE ONLY

2

3

4

2

5

1

1

USB

For software update only.

2

HDMI OUT 5/6/7/8

HDMI equipped displays connected to these slots will display the 

same content that is input from the HDMI IN slot.

3

SYS Reset ON/OFF

This switch allows user to perform a system reset. The default setting 

is OFF, leave as is when in normal use. When switched ON, the unit 

will perform a system reset every 8~10 minutes, in order to perform 

this function the displays must have CEC support. When performed 

successfully, the unit will automatically switch the displays to the 

HDMI 1 input.

NOTE: For the system reset function to work will not affect displays 

that are not CEC compatible.

4

EDID Control switch

This EDID control switch determines if you are going to use the 

EDID from the display attached to output 1 or use an onboard 

EDID. When TV is selected, the EDID will attach to output 1 and 

will accept a 3D signal input to display on the 3D TV. When STD is 

selected, the EDID will become onboard EDID. The factory default 

setting is TV mode. 

5

Power

Plug the 5 V DC power supply into the unit and connect the 

adaptor to AC wall outlet.