CYP CPLUS-V2E, Operation Manual

3

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Front Panel

6G

IN

OUT 1 OUT 2

SYNC
HDCP

EDID

STD TV

SYS-RST

ON OFF

POWER

3G

1 2 4 6

5

3

7

8

1

 POWER:

 This LED will illuminate when the device is connected to an 

active power supply.

2

 6G/3G:

 When input source bandwidth is 6G, the 6G LED will 

illuminate, when input source detect as 3G, the 3G LED will 

illuminate.

3

 IN SYNC:

 When input detected, the LED will illuminate, the LED will 

flicker when detected abnormal, for example, when source signal 

not stabled, and when input is not connected, the LED light will off. 

4

 IN HDCP:

 When Input HDCP has been detected, the LED will 

illuminate, the LED will flicker when HDCP abnormal, for example 

when HDCP version is not supported, and when no HDCP 

detected, the LED will off.

5

 OUT 1~2 SYNC:

 When output detected, the LED will illuminate, 

the LED will flicker when detected abnormal, for example, when 

output connected but the output sense is off, and when output is 

not connected, the LED will off.

6

 OUT1~2 HDCP:

 When output HDCP working, the LED will illuminate, 

the LED light flicker when HDCP abnormal, for example, when 

HDCP version is not supported, and when no HDCP detected, the 

LED will off.

7

 EDID:

 Switch the dip could choose EDID mode to Standard (STD) 

mode or TV mode. When on TV mode, the unit will automatically 

detect and store output 1 sink EDID data, if switch to STD mode, 

the unit will set to standard 1080p and PCM 2 channel.

8

 SYS-RST:

 Switch the dip from off to on, the unit will trigger TV to it’s 

HDMI input1 immediately, when dip stays in on, the unit will trigger