6
1) Power In:
Displays the voltage, current and wattage of the unit’s
main power supply.
2) Power Out:
Displays the voltage, current and wattage of each of
the 8 individual power outputs.
3) System Temperature:
Displays the unit’s temperature as measured
at 3 locations inside the case on the PCB.
4) System Fan:
Displays the current state of 2 external fans (optional)
including individual fan RPM, and the current fan speed thresholds,
if auto mode is enabled.
• Device
This tab provides controls for all 8 power output ports as well as control
over the optional external fans’ speed and temperature thresholds.
1) Power Out:
This section provides control over each individual
power output. The outputs may be turned on, turned off, and
renamed.
2) Fan Setting:
This section provides controls for any connected fans.
When Auto Fan Mode is enabled the fan speed will be controlled
based on the 3, user set, temperature thresholds and speed
selections. The preferred fan speed at each threshold is also user
configurable. If Auto Fan Mode is disabled, the fan speed can
be set as a static percentage of maximum power. If 2 fans are
connected to the unit, both will follow the same settings.
Note: The highest of the 3 System Temperature measurements is
used to determine which Auto Fan Mode speed (low, middle, or
high) is active when Auto Fan Mode is enabled.
