14
6.5 Telnet Control
Before attempting to use Telnet control, please ensure that both the unit
and the PC are connected to the same active networks.
Start your preferred Telnet/Console client, or use the built in client
provided by most modern computer operating systems. After starting
the client, connect by using the current IP address of the unit and port
23 (if the communication port number used by the unit has not been
changed previously). This will connect us to the unit we wish to control
and commands may now be entered directly.
Note 1: If the IP address of the unit is changed then the IP address required for
Telnet access will also change accordingly.
Note 2: This unit defaults to Auto IP mode. The current IP address can be
verified using the Device Discovery software. The default communication port
is 23.
6.6 Serial and Telnet Commands
COMMAND
Description and Parameters
help
Show the full command list.
help N1
Show details about the specified command.
N1 = {Command}
get fw ver
Show the unit’s current firmware version.
get hw ver
Show the unit’s current hardware version
get command ver
Show the unit’s current command version.
get mac addr
Show the unit’s MAC address.
Summary of Contents for IP-A750RX
Page 1: ...IP A750RX Audio over IP Receiver for IP 7000 series OPERATION MANUAL ...
Page 2: ......
Page 31: ......
