CYP PU-2H8HBTE-AD, Operation Manual

9

being used is within the direct line-of-sight of the IR Extender.

4

LAN:

 Connect to intranet or internet service system for a total sharing 

rate of 100Mbps within the link of Transmitter.

Warning:

 DO NOT connect this slot with any of the CAT5e/6/7 port, doing 

so may trigger a power shot down and ruin the device.

5

L/R OUT:

 Connect to active speaker or audio equipment for audio 

signal output.

6

OPTICAL OUT: 

Connect to active speaker or audio equipment for 

audio signal output.

7

HDMI OUT: 

Connect to HDMI display for instant image display or 

cascade with another family type Transmitter.

8

HDMI IN1/2:

 Connect with source equipment such as DVD/Blu-ray or 

PS3 player.

9

EDID STD/TV:

 The default factory setting is on TV, leave as it is when 

the display is properly. The unit will detect first the HDMI output’s 

EDID and send out the signal accordingly to other output ports. If 

the HDMI output port is not connected the device will detect the 1st 

CAT5e/6/7 output's EDID and send out the signal accordingly to all 

outputs.

This device obtain the last memory function therefore, the device will 

use the last HMDI output port/the 1st CAT5e/6/7's output EDID after 

power cycling or switch in between the EDID setting.

Switch to STD to use build-in EDID if the display has problem. STD 

EDID's video at 1080p@60Hz and audio at LPCM 2CH.

10

SERVICE:

 This slot is reserved for factory service only.

11

RS-232:

 Connect this slot from PC/Laptop for RS-232 command 

sending.

12

DC 24V:

 Plug the 24V DC power supply into the unit and connect the 

adaptor to an AC outlet.