10
6.3 Receiver Front Panel
IR
POWER
LAN
RS232 OUT
LINK
HDMI OUT
UPDATE
IN 1
OUT 2
PUV-1510RXWP
7
8
6
2 1
5
4
3
1
POWER:
This LED will illuminate when the device is receiving power
via PoE (Power over Ethernet).
2
LINK:
This LED will illuminate solid when both Transmitter and
Receiver are connected and communicating with each other properly.
3
LAN:
Connect to an Ethernet device or to your local network as
appropriate.
4
RS232 OUT:
Connect (via D-Sub 9-pin female cable) to the device that
is to be controlled by RS-232 commands.
5
HDMI OUT:
Connect to an HDMI equipped display such as an HDTV or
projector for display of the HDMI input source signal.
6
IR IN 1:
Connect to the supplied IR Extender cable for IR signal
reception. Ensure that remote being used is within the direct line-of-
sight of the IR Extender.
7
IR OUT 2:
Connect to the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
8
UPDATE:
This switch is reserved for factory use only.
Summary of Contents for PUV-1510RXWP
Page 1: ...PUV 1510TXWP RXWP HDMI over CAT5e 6 7 Wallplate Transmitter with 48V PoH OPERATION MANUAL ...
Page 2: ......
Page 18: ......
Page 19: ......