8
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front Panel
IR
OUT 1
IN 2
UPDATE
RS232 IN
POWER
LAN
LINK
HDMI IN
PUV-1510TXWP
7
8
6
2 1
5
4
3
1
POWER:
This LED will illuminate when the device is connected to a
power supply.
2
LINK:
This LED will illuminate solid when both Transmitter and
Receiver are connected and communicating with each other properly.
3
LAN:
Connect to an Ethernet device or to your local network as
appropriate an internet or network system.
4
RS232 IN:
Connect to a PC or laptop with D-Sub 9-pin male cable for
the transmission of RS-232 command.
5
HDMI IN:
Connect to the HDMI source equipment such as a game
console or Blu-ray player.
6
IR IN 2:
Connect to the supplied IR Extender cables for IR signal
reception. Ensure that remote being used is within the direct line-of-
sight of the IR Extender.
7
IR OUT 1:
Connect to the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
8
UPDATE:
This switch is reserved for factory use only.
Summary of Contents for PUV-1510RXWP
Page 1: ...PUV 1510TXWP RXWP HDMI over CAT5e 6 7 Wallplate Transmitter with 48V PoH OPERATION MANUAL ...
Page 2: ......
Page 18: ......
Page 19: ......
