9
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
CONSOLE/
BYPASS
RX
RS-232
SERVICE
OPT. OUT
DC 48V
+
-
POWER
LINK
TX
IR BLASTER 2
IR EXTENDER 1
1 2
3
4 5
6
7
8
1
DC 48V:
Plug the 48V DC power adapter into this port and connect it
to an AC wall outlet for power.
Note: Please be sure to follow the polarity labels on the unit and the
adapter’s wires.
2
POWER LED:
This LED will illuminate to indicate the unit is on and
receiving power.
LINK LED:
This LED will illuminate solidly when a live connection with
a compatible Receiver is active.
3
OPT. OUT:
Connect to powered speakers or an amplifier for digital
audio output using an appropriate optical cable. Audio is sourced
from the Optical Audio Return input on a connected compatible
Receiver.
4
IR EXTENDER 1:
Connect to an IR Extender to extend the IR control
range of devices connected to the other end of the HDBaseT
connection. Ensure that the remote being used is within direct line-of-
sight of the IR Extender.
5
IR BLASTER 2:
Connect to the provided IR Blaster to transmit IR
signals from the other end of the HDBaseT connection to devices
within direct line-of-sight of the IR Blaster.
6
SERVICE:
This USB port is reserved for firmware update and user EDID
upload use.
7
RS-232:
Connect to a PC, laptop or other serial control device with a
3-pin adapter cable for the extension of RS-232 signals to the Receiver
in "Bypass" mode, or for control this unit when in "Console" mode.
Note: Depending on the controlled device connected to the Receiver side,
Summary of Contents for PUV-1730PLTX-AVLC
Page 1: ...PUV 1730PLTX AVLC HDBaseT HDR Transmitter 70m 4K HDCP2 2 PoH OAR 18Gbps OPERATION MANUAL ...
Page 2: ......
Page 27: ......
