27
COMMAND
DESCRIPTION & PARAMETERS
GET OUT N1 HDCP STATUS
Show the current HDCP status of Output N1.
N1
= A ~ H
[Output Port]
Valid response values are:
0
[No HDCP]
1
[HDCP 1.4 Active]
2
[HDCP 2.2 Active]
3
[HDCP 1.4 Retrying]
4
[HDCP 2.2 Retrying]
GET OUT N1 EDID DATA
Show the raw hex data of the EDID read from Output N1.
N1
= A ~ H
[Output Port]
GET OUT N1 EDID INFORMATION
Show a description of the EDID read from Output N1.
N1
= A ~ H
[Output Port]
User EDID Commands
GET USER EDID NUMBER
Show the number of User EDIDs supported by the unit.
SET USER N1 EDID DATA N2
Update the contents of User EDID N1 with new raw hex data.
N1
= 1 ~ 2
[User EDID Number]
N2
= {Hex Data}
[Raw EDID Hex Data]
GET USER N1 EDID DATA
Show the raw hex data of the EDID stored in User EDID N1.
N1
= 1 ~ 2
[User EDID Number]
