© 2018 Cyphre Security Solutions, LLC.
5 – 165
BT1 Security Appliance User Guide
5 About the IPMITool
5.6 Command: bmc|mc
reset <warm|cold>
Instructs the BMC to perform a warm or cold reset.
guid
Displays the Management Controller Globally Unique Identifier.
info
Displays information about the BMC hardware, including device revision, firmware
revision, IPMI version supported, manufacturer ID, and information on additional
device support.
watchdog
These commands allow a user to view and change the current state of the watchdog
timer.
get
Show current watchdog timer settings and countdown state.
reset
Reset the watchdog timer to its most recent state and restart the countdown
timer.
off
Turn off a currently running watchdog countdown timer.
selftest
Check on the basic health of the BMC by executing the Get Self Test results command
and report the results.
getenables
Displays a list of the currently enabled options for the BMC.
setenables <option>=[on|off]
Enables or disables the given option. This command is only supported over the system
interface according to the IPMI specification. Currently supported values for option
include:
recv_msg_intr
Receive Message Queue Interrupt
event_msg_intr
Event Message Buffer Full Interrupt
event_msg
Event Message Buffer
system_event_log
Confidential
