3 – 68
© 2018 Cyphre Security Solutions, LLC.
3.16 Hard Drive Assembly Removal
Hard drives are installed in caddies, which together makeup a hard drive assembly. These can be
removed or replaced in the datacenter by a qualified technician. Because the hard drives plug
directly into the SATA connector wall, there are no cables or wires to manage.
Note:
Hard Drive Assemblies cannot be removed or installed while
the appliance is connected to power.
The hard drive assembly is fitted with a push-push latching device. When you remove an assembly
from its bay, press gently to release the latch. The assembly handle will extend. See the table below.
Description
Illustration
Push-push Latch Locked
Push-push Latch Depressed
Push-push Latch Released Show-
ing Handle
Table 3 - 4. Push-push Latch Assembly Operation
Use ESD best practices to avoid electrostatic discharge on or within the appliance.
Utilisez les meilleures pratiques ESD pour éviter une décharge électrostatique sur ou
dans le serveur.
Confidential
BT1 Security Appliance User Guide
3 BT1 Installation
