Cypress Envirosystems
Doc # 152-10101-01 Rev 1.2
WGR User Manual
Page 10
CAUTION: Always wear appropriate PPE when working on live lines.
5.0
Operation
There are various functions that can be performed both through the web interface and at the WGR. This
section describes how to perform functions at the WGR.
5.1
Configuration
Configuration of the WGR must be performed by a qualified service technician. See Section 10.0, Support,
for details.
The service technician will configure and calibrate the WGR to the specific gauge parameters (range and
units). The WGR supports the following units.
•
PSI, bar, mbar, kPa, MPa, inHg, mmHg, inH2O, ftH2O, cmH2O, mmH2O, kg/cm2
•
Deg F, Deg C
•
Volts, mVolts, uVolts
•
Amps, mAmps, uAmps
•
Blank
Additional units can also be supported as needed. Please contact us for more information.
5.2
Turning the WGR On and Off
On
1.
Press “
●
” “
●
” “
►
” “
◄
”“
●
” sequence of buttons.
2.
WGR display should read BOOT.
3.
Once boot-up is complete, display should show 0.0.
Off
1.
Press “
►
” to access menu.
2.
Press “
►
” until the bottom right side of the display reads SETUP.
3.
Press “
●
” to select this option. The next screen should ask for the password and read PSWD?.
4.
Press “
●
” “
●
” “
►
” “
◄
” “
●
” sequence of buttons. The bottom right side of the display should read
SHIP.
5.
Press “
●
” to select this option. The LCD should read SHIP briefly, and then turn off.
5.3
Setting Sampling Rates
Manual instantaneous reading
To take a one-time reading, press the “
●
” button. The WGR will show SAMPLE in the top left corner.
When SAMPLE disappears, the reading on the LCD will be updated.
Routine data collection
Whenever the WGR is on, it samples based on the routine data collection rate. This rate is between 0 and
65535 seconds, or approximately 18 hours. This value is defined by the user, and can be changed at the
WGR.
1.
Press “
►
” to access the WGR menu.
2.
Press “
►
” until the bottom right side of the display reads DATA.
3.
Press “
●
” to select this option. Press “
◄
” if you need to cancel and return to the main screen.
4.
Once in the DATA menu, press “
►
” until you reach the UPDTE submenu.
