Cypress Envirosystems
Doc # 152-10101-01 Rev 1.2
WGR User Manual
Page 11
5.
Press “
●
” to edit the update rate. ** This feature is password protected. **
6.
Enter the WGR password.
7.
The bottom right side of the display should read UPDTE?
8.
Use the “
◄
” and “
►
” to change the update rate and press “
●
” to save the change and return to the
UPDTE menu.
Preprogrammed short term data collection intervals.
In addition to the routine data collection rate, there are two pre-programmed short term data collection
intervals associated with the WGR, FAST and MED (medium).
FAST
The FAST sample mode collects data at a 5-second interval for a 5-minute duration. While the WGR is in
the FAST sample mode, the units of data will have an “*” at the end.
1.
Press “
►
” to access the WGR menu. The bottom right side of the display should read FAST.
2.
Press “
●
” to select this option. Press “
◄
” to cancel and return to the main screen.
3.
Press “
●
” during the modified sample mode to cancel and return to the normal sample mode.
MED
The MED sample mode collects data at a 30-second interval for an 8-hour duration. While the WGR is in
the MED sample mode, the units of data will have an “m” at the end.
1.
Press “
►
” to access the WGR menu.
2.
Press “
►
” again. The bottom right side of the display should read MED.
3.
Press “
●
” to select this option. Press “
◄
” to cancel and return to the main screen.
4.
Press “
●
” during the modified sample mode to cancel and return to the normal sample mode.
5.4
Accessing Node Identification Data
Each WGR has a unique NODE ID identifier. This NODE ID is a value between 0 and 255 and is used to
identify the data within the database and the web interface. The NODE ID is assigned when the WGR is
configured. Changing the NODE ID at the WGR will impact the ability to collect data at the server.
However, viewing the NODE ID of the WGR will make it easy to differentiate one WGR from another,
should they get mixed up.
1.
Press “
►
” to access the WGR menu.
2.
Press “
►
” until the bottom right side of the display reads DATA.
3.
Press “
●
” to select this option.
4.
The NODE ID will show on the display.
5.
Press “
●
” to edit the NODE ID. ** This feature is password protected. **
6.
Enter the WGR password.
7.
The bottom right side of the display should read NODE?
8.
Use the “
◄
” and “
►
” to change the NODE ID and press “
●
” to save the change and return to the
NODE menu.
5.5
Accessing Informative Data Parameters in the WGR
Several data parameters can be viewed, but not edited in the WGR’s DATA menu. The following
parameters are available:
1.
Node ID
2.
Firmware Version
3.
Internal Temperature
Follow these steps in order to access the parameters in the DATA menu:
